[OpenSIPS-Users] Problem with HEP-monitoring of tls_wolfssl
Bogdan-Andrei Iancu
bogdan at opensips.org
Wed Aug 10 07:53:40 UTC 2022
Hi Artiom,
So you initially had only the trace_on set in the proto_tls module,
generating some HEP packages which were not understood by HOMER, right ?
And after setting the trace_on in the proto_tcp module, the issue went
away? but do you get HEP packages about about the TCP and TLS events in
OpenSIPS - I'm asking as I have to say this part was not tested by some
time :-/
Regards,
Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
https://www.opensips-solutions.com
OpenSIPS Summit 27-30 Sept 2022, Athens
https://www.opensips.org/events/Summit-2022Athens/
On 8/10/22 5:44 AM, Artiom Druz wrote:
> Hi Bogdan.
> I use trace_on parameter of proto_tls module and subroute for sending
> messages to Homer.
>
> I enabled trace_on parameter for proto_tcp module and now it works
> correct. I'm not sure if this is the only fix I made because it may
> have been a misconfiguration in the script logic.
>
> вт, 9 авг. 2022 г., 13:42 Bogdan-Andrei Iancu <bogdan at opensips.org
> <mailto:bogdan at opensips.org>>:
>
> Hi Artiom,
>
> Do you use any proto TCP or TLS specific tracing (like [1]), or
> only pure SIP TLS tracing ?
>
> [1]
> https://opensips.org/html/docs/modules/3.2.x/proto_tls.html#param_trace_on
> <https://opensips.org/html/docs/modules/3.2.x/proto_tls.html#param_trace_on>
>
> Regards,
>
> Bogdan-Andrei Iancu
>
> OpenSIPS Founder and Developer
> https://www.opensips-solutions.com <https://www.opensips-solutions.com>
> OpenSIPS Summit 27-30 Sept 2022, Athens
> https://www.opensips.org/events/Summit-2022Athens/ <https://www.opensips.org/events/Summit-2022Athens/>
>
> On 7/25/22 11:20 AM, Artiom Druz wrote:
>> Hello Everyone.
>> I have a problem with monitoring SIPS/TLS based on tls_wolfssl
>> module via proto_hep (target monitoring service is Homer 7).
>> My opensips config works ok with SIP/UDP, but when I make a call
>> via TLS (OpenSIPS convert TLS from VoIP provider to internal
>> SIP/UDP software PBX) in dump file on Homer 7 side I see that all
>> packets in HEP3 payload has this info:
>>
>> HEP3 Protocol
>> HEP Version: HEP3
>> HEP Packet Size (Bytes): 152
>> IP family: IPv4
>> Ingested Transport Protocol: IPv4
>> Source port: 0
>> Destination port: 0
>> Unix Timestamp: 1658731857
>> Timestamp µs: 106136
>> Application Protocol: Unknown Application Protocol
>> Capture Node ID: 1301
>> Source IPv4 address: 127.0.0.2
>> Destination IPv4 address: 127.0.0.2
>> Encapsulated Payload: TLS:CLOSED:SUCCESS:Read error
>> Correlation ID: 350784072629638188
>>
>> Only unix timestamp and capture node id is correct.
>> As you can see in encapsulated payload I have an error with read.
>> What can be wrong?
>>
>> OpenSIPS 3.2.5 (git revision 7e284ab03) compiled from source.
>>
>> _______________________________________________
>> Users mailing list
>> Users at lists.opensips.org <mailto:Users at lists.opensips.org>
>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users <http://lists.opensips.org/cgi-bin/mailman/listinfo/users>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opensips.org/pipermail/users/attachments/20220810/7dd1fcd3/attachment.html>
More information about the Users
mailing list