[OpenSIPS-Users] Opensips Multi instance issue on SIP TLS

feroze waris feroze.chaudhry at gmail.com
Fri Apr 8 16:48:07 CEST 2016


Ben

I have put the address of my interface

Regards
Feroze

On Fri, Apr 8, 2016 at 7:39 PM, Benjamin Cropley <benjamin.cropley at gmail.com
> wrote:

> Feroze
>
> Can I just check.. in the listen variable have you put the address of your
> interface or 1.2.3.4?
>
> You need to put your address.. not 1.2.3.4....
>
> On Fri, Apr 8, 2016 at 3:30 PM, feroze waris <feroze.chaudhry at gmail.com>
> wrote:
>
>> Hi ben
>>
>> As you said i have enabled the listen=tls:1.2.3.4:5061 on receiving
>> proxy as well.  Now i am getting the following error in this case
>>
>> Apr  8 14:08:12 localhost OPENSIPS[623]: ERROR:tm:msg_send: send() for
>> proto 3 failed
>> Apr  8 14:08:12 localhost OPENSIPS[623]: ERROR:tm:t_forward_nonack:
>> sending request failed
>> Apr  8 14:08:12 localhost OPENSIPS[623]: ERROR:tm:w_t_relay:
>> t_forward_nonack failed
>>
>>
>> regards
>> Feroze
>>
>> On Fri, Apr 8, 2016 at 1:15 PM, Benjamin Cropley <
>> benjamin.cropley at gmail.com> wrote:
>>
>>> Feroze,
>>>
>>> I think you misunderstood :)
>>>
>>> I was saying, the URI has ;transport=tls, but the receiving server
>>> probably doesn't have a port open to listen for it.. Don't remove this if
>>> you want to use TLS, as by using rewrite() you're effectively breaking TLS
>>> ;)
>>>
>>> In the documentation it says if you dont specify a listen= variable,
>>> then it will listen on 'all interfaces'. It doesn't say whether it will
>>> listen to UDP TCP and TLS. But I would guess it's possibly only UDP and TCP.
>>>
>>> Therefore, make sure on the servers receiving the packets that you
>>> specifically set a tls listening interface with listen = tls:
>>> 1.2.3.4:5061
>>>
>>> Good luck
>>> Ben
>>>
>>>
>>> On Fri, Apr 8, 2016 at 7:29 AM, feroze waris <feroze.chaudhry at gmail.com>
>>> wrote:
>>>
>>>> Hi ben
>>>>
>>>> I have checked the traces and you were right that there was transport =
>>>> tls in RURI when request forwards from load balancer  to 2 opensips
>>>> instances . I have replaced the RURI using rewrite() function and removed
>>>> the transport parameter but the issue remains and i am getting the same
>>>> error
>>>>
>>>>
>>>> regards
>>>> Feroze
>>>>
>>>> On Thu, Apr 7, 2016 at 1:09 PM, Benjamin Cropley <
>>>> benjamin.cropley at gmail.com> wrote:
>>>>
>>>>> Wild guess here, based on what I've read..
>>>>>
>>>>> It might be your request URI is explicitly declaring which protocol to
>>>>> use, and OpenSIPS has no interface configured for that protocol.. eg.
>>>>> ;transport=tls is added to the request URI but there's no listen = tls:
>>>>> 1.2.3.4:5061
>>>>>
>>>>> I know it's tricky to look at a trace for TLS. But have a look at
>>>>> http://wiki.snom.com/FAQ/How_to_decode_TLS_calls_using_wireshark
>>>>>
>>>>> Good luck
>>>>> Ben
>>>>>
>>>>> On Wed, Apr 6, 2016 at 6:24 PM, feroze waris <
>>>>> feroze.chaudhry at gmail.com> wrote:
>>>>>
>>>>>> Hi ben
>>>>>>
>>>>>> yes i am load balancing the Register and Invite request to two proxy
>>>>>> servers using dispatcher module but all three servers (i.e load balncer and
>>>>>> two opensips servers) are sharing same opensips database.
>>>>>> This issue is not occurring in UDP call but on TLS this error occurs.
>>>>>>
>>>>>> Regards
>>>>>> Feroze
>>>>>>
>>>>>> On Wed, Apr 6, 2016 at 7:34 PM, Benjamin Cropley <
>>>>>> benjamin.cropley at gmail.com> wrote:
>>>>>>
>>>>>>> Feroze,
>>>>>>>
>>>>>>> Are you load balancing REGISTER *and *INVITE requests to different
>>>>>>> nodes?
>>>>>>>
>>>>>>> If so, then unless you share location information between the
>>>>>>> Registrars, then they wont all know where to route INVITEs.
>>>>>>>
>>>>>>> Ben
>>>>>>>
>>>>>>>
>>>>>>> On Wed, Apr 6, 2016 at 3:20 PM, feroze waris <
>>>>>>> feroze.chaudhry at gmail.com> wrote:
>>>>>>>
>>>>>>>> Hello
>>>>>>>>
>>>>>>>> I have one load balancer connected to 2 opensips server
>>>>>>>> Request is balancing through dispatcher module on load balancer
>>>>>>>> the problem is when Register request of B party lands on different
>>>>>>>> server than that server at which A Party sends invite request the call
>>>>>>>> drops and i am getting following error
>>>>>>>> Apr  6 07:58:31 localhost OPENSIP[1793]: ERROR:tm:update_uac_dst:
>>>>>>>> failed to fwd to af 2, proto 3  (no corresponding listening socket)
>>>>>>>> Apr  6 07:58:31 localhost OPENSIP[1793]: ERROR:tm:t_forward_nonack:
>>>>>>>> failure to add branches
>>>>>>>> Apr  6 07:58:31 localhost OPENSIP[1793]: ERROR:tm:w_t_relay:
>>>>>>>> t_forward_nonack failed
>>>>>>>>
>>>>>>>> I am using Openisps version 2.1.1 and using TLS on it
>>>>>>>>
>>>>>>>>
>>>>>>>> Regards
>>>>>>>> Feroze
>>>>>>>>
>>>>>>>> _______________________________________________
>>>>>>>> Users mailing list
>>>>>>>> Users at lists.opensips.org
>>>>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>>>>>>
>>>>>>>>
>>>>>>>
>>>>>>> _______________________________________________
>>>>>>> Users mailing list
>>>>>>> Users at lists.opensips.org
>>>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>>>>>
>>>>>>>
>>>>>>
>>>>>> _______________________________________________
>>>>>> Users mailing list
>>>>>> Users at lists.opensips.org
>>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>>>>
>>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> Users mailing list
>>>>> Users at lists.opensips.org
>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>>>
>>>>>
>>>>
>>>> _______________________________________________
>>>> Users mailing list
>>>> Users at lists.opensips.org
>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>>
>>>>
>>>
>>> _______________________________________________
>>> Users mailing list
>>> Users at lists.opensips.org
>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>
>>>
>>
>> _______________________________________________
>> Users mailing list
>> Users at lists.opensips.org
>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>
>>
>
> _______________________________________________
> Users mailing list
> Users at lists.opensips.org
> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opensips.org/pipermail/users/attachments/20160408/fd9e0a35/attachment-0001.htm>


More information about the Users mailing list