[OpenSIPS-Users] uac_replace_to problem
M.Khaled W Chehab
kchehab at icucall.com
Wed Jun 19 15:18:21 CEST 2013
while i am using uac_replace_to in failover route branch i can find that TO
header is not changed(sip user part ) but appended an new raw as I want it
to be To: "971552448304" <sip: 808971552448304 at xx.xx.xx.55>
SIP to address:
sip:835822971552448304 at xx.xx.xx.55sip:808971552448304 at xx.xx.xx.55
SIP to address User Part: 835822971552448304
SIP to address Host Part: xx.xx.xx.55sip
SIP to address Host Port: 808971552448304 at xx.xx.xx.55
please advice
regards
From: M.Khaled W Chehab [mailto:kchehab at icucall.com]
Sent: Wednesday, June 19, 2013 2:41 PM
To: users at lists.opensips.org
Cc: users-bounces at lists.opensips.org
Subject: uac_replace_to problem
Hi,
I am running opensips 1.8.3 with do_routing module
A dial_rule prefix has 3 trunk gateways ( gw1,gw2,gw3)
After do_routing(,)
I am setting the $rU and fixing the To Tag header using uac_replace_to( and
the call go to gw1 with correct TO tag as I set it ,
but when calls fails on gw1 ,then I set the $rU in route[6] to go to second
in route and it goes with bad TO header, since it goes with the same To
header in the 1st invite
That target gw1
1-how to fix the To header in the second invite to gw2
loadmodule "uac.so"
modparam("uac","restore_mode","auto")
uac_replace_to("$avp(dst)","sip:$var(prefix)$avp(dst)@$td");
t_on_failure("1");
on failure_route[1] {
.
if (!t_check_status("487")) {
#xlog("------------route6-------\n");
$avp(failure_count) = $avp(failure_count) + 1;
#480|486|603
route(6);
}
Route[6]{
.
.
.
$rU = $var(prefix) + $avp(dst);
uac_replace_to("sip:$var(prefix)$avp(dst)@$td");
}
Regards
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opensips.org/pipermail/users/attachments/20130619/f958ceed/attachment.htm>
More information about the Users
mailing list