[OpenSIPS-Users] sst min-se problem

[Bogdan-Andrei Iancu]

Looking in the code, the 422 is sent only if the proxy min-se (1800) is 
smaller than the min(received-min_se(90), received-se(300)) -> 1800 < 90 
-> false, no 422.

But reading the RFC 4028, I would say the condition is the other way 
around - if the local min-se is higher than min(received-min_se(90), 
received-se(300)) , the 422 should be sent out.

Regards,
Bogdan

Jeff Pyle wrote:
> Hi Bogdan,
>
> Makes sense, but the why didn't the proxy reject the request with a 422
> since the Session-Expires from the request is less than the proxy's Min-SE
> of 1800?
>
>
> - Jeff
>
>
>
> On 4/6/09 12:56 PM, "Bogdan-Andrei Iancu" <bogdan at voice-system.ro> wrote:
>
>   
>> Hi Jeff,
>>
>> What you configure is the min-se of the proxy. (1800)
>>
>> In
>>     DBG:sst:sst_check_min: Session-Expires: 300; MIN-SE: 90
>>
>> are the values from received from request.
>>
>> Regards,
>> Bogdan
>>
>> Jeff Pyle wrote:
>>     
>>> Hello,
>>>
>>> I have the sst module configured as follows:
>>>
>>> loadmodule "sst.so"
>>> modparam("sst|dialog", "timeout_avp", "$avp(s:sst_timeout)")
>>> modparam("sst", "sst_flag", 6)
>>> modparam("sst", "enable_stats", 1)
>>> modparam("sst", "min_se", 1800)
>>> modparam("sst", "reject_to_small", 1)
>>>
>>>
>>> Opensips 1.5 receives an invite containing the following header:
>>>
>>>   Session-Expires: 300
>>>
>>> sstCheckMin("1") at debug=6 shows this:
>>>
>>>   DBG:sst:sst_check_min: No MIN-SE header found.
>>>   DBG:sst:sst_check_min: Session-Expires: 300; MIN-SE: 90
>>>   DBG:sst:sst_check_min: Done returning false (-1)
>>>
>>>
>>> Since the invite from my gateway didn't contain a MIN-SE, why doesn't it use
>>> the 1800 provided at the modparam?
>>>
>>>
>>> Thanks,
>>> Jeff
>>>
>>>
>>> _______________________________________________
>>> Users mailing list
>>> Users at lists.opensips.org
>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>
>>>   
>>>       
>
>
>