[OpenSIPS-Devel] "Early cancel" issue in the tm module

Bogdan-Andrei Iancu bogdan at opensips.org
Tue Dec 8 14:17:21 CET 2015


Hi  Maxim,

In the current implementation, if there was no reply received for the 
INVITE, on canceling opensips stops retransmissions for INVITE and 
replies with 487 to it.

As I understand, you suggest as a better approach to keep doing the 
retransmissions until either there is an incoming reply, either an 
internal timeout is generated and a 408 is sent back to UAC.

The advantage you invoke is related to slow/delayed provisional replies 
- replies that you might received after the CANCEL and after OpenSIPS 
sent back the 487 (while the UAS may answer with 200 OK). Well, this 
scenario may happen (maybe with the smaller probability) also if we 
follow your suggestion ...actually it may happen in any internal timeout 
scenario. Based on FR timer, OpenSIPS sends back 408 in 5 seconds, while 
the UAS sends a 200 OK in 7 seconds....what to do here :) ? OpenSIPS 
follows the RFC3261 and lets any 200 OK to pass, even if the transaction 
was completed - this is done to allow the end points to sort it out 
(without blaming the proxy in the middle).

So, IMHO, the issue you are trying to improve exists anyhow (like a late 
183/200 after a local timeout) and it is handled as per RFC. The 
downside of your approach is the ambiguity - if the UAC sends a CANCEL, 
it expects a 487 or 200 back, but not a timeout....

What do you think ?

Best regards,

Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
http://www.opensips-solutions.com

On 16.11.2015 21:21, Maxim Sobolev wrote:
> Bogdan, thanks for looking into this for me. So OpenSIPS is somewhat 
> better than original code, but still not perfect. This method would 
> work if the INVITE has been lost or never received, but would still 
> produce inconsistent transaction state if provisional reply has been 
> lost and INVITE in fact is being processed by the far end. Then you 
> might not hear from the downstream UAS until much later when it 
> follows up with either 18x or even 200 OK.
>
> There is no pre-cooked recipe for a stateful proxy in the RFC, but 
> general UAC CANCEL benaviour is defined pretty clearly, please see 
> excerpt below. Note the fact that INVITE and CANCEL transactions need 
> to complete independently, so UAC needs to continue re-transmit INVITE 
> and hold on to locally generated 487.
>
> If the INVITE transaction timeouts then I think local 408 can be 
> generated to the UAC by the tm module.
>
> I am pretty sure this would be RFC-correct behavior, but if you are 
> still in doubt, I can also raise this question on sip-implementors 
> mailing list and see what the community thinks.
>
> 9.1 Client Behavior
>
> [...]
>    header fields.
>
>    Once the CANCEL is constructed, the client SHOULD check whether it
>    has received any response (provisional or final) for the request
>    being cancelled (herein referred to as the "original request").
>
>    If no provisional response has been received, the CANCEL request MUST
>    NOT be sent; rather, the client MUST wait for the arrival of a
>    provisional response before sending the request.  If the original
>    request has generated a final response, the CANCEL SHOULD NOT be
>    sent, as it is an effective no-op, since CANCEL has no effect on
>    requests that have already generated a final response.  When the
>    client decides to send the CANCEL, it creates a client transaction
>    for the CANCEL and passes it the CANCEL request along with the
>    destination address, port, and transport.  The destination address,
>    port, and transport for the CANCEL MUST be identical to those used to
>    send the original request.
>
>       If it was allowed to send the CANCEL before receiving a response
>       for the previous request, the server could receive the CANCEL
>       before the original request.
>
>    Note that both the transaction corresponding to the original request
>    and the CANCEL transaction will complete independently.  However, a
>    UAC canceling a request cannot rely on receiving a 487 (Request
>    Terminated) response for the original request, as an RFC 2543-
>    compliant UAS will not generate such a response.  If there is no
>    final response for the original request in 64*T1 seconds (T1 is
>
>
>
>
> Rosenberg, et. al.          Standards Track        [Page 54]
> 
> RFC 3261            SIP: Session Initiation Protocol         June 2002
>
>
>    defined in Section 17.1.1.1), the client SHOULD then consider the
>    original transaction cancelled and SHOULD destroy the client
>    transaction handling the original request.
>
>
> On Sat, Nov 14, 2015 at 1:06 PM, Bogdan-Andrei Iancu 
> <bogdan at opensips.org <mailto:bogdan at opensips.org>> wrote:
>
>     Hi Maxim,
>
>     Thank you for your detailed email on the matter. Indeed, if there
>     is no reply received on the branch, OpenSIPS internally cancel the
>     branch (stops retransmissions and generates a 487 reply for the
>     INVITE). Nevertheless, the branch gets marked as canceled and as
>     soon as a reply is received on it (provisional), a CANCEL will be
>     fired to UAS. Of course, the reply must be received within the
>     transaction lifetime (wait timer).
>
>     With the approach you mentioned:
>         - could you point to the RFC section mentioning this behavior ?
>         - what happens if there is no reply at all from UAS ?
>
>     Best regards,
>
>     Bogdan-Andrei Iancu
>     OpenSIPS Founder and Developer
>     http://www.opensips-solutions.com
>
>
>     On 13.11.2015 01:41, Maxim Sobolev wrote:
>
>         Hi Volks, there seems to be an issue in the way how the tm
>         handles early CANCEL, i.e. when a CANCEL arriving before the
>         downstream UAS gets chance to generate a 100 Trying reply, or
>         that reply is still in flight (or maybe 100 Trying is lost).
>         In that case the OpenSIPS stops outbound INVITE re-transmits
>         and generates both 200 OK for CANCEL and 487 Transaction
>         Terminated for the INVITE. This only works if initial INVITE
>         has not reached the target UAS, otherwise inconsistent state
>         of session is produced, with UAC thinking that the transaction
>         is over with, while the UAS is still proceeding with call
>         setup. Needless to say this can produce all kind of weird
>         things ranging from irritated users to billing mismatches.
>
>         This behavior comes from the RFC requirement that UAC cannot
>         generate CANCEL until at least one provisional reply has
>         arrived, but implementation is completely wrong in my view.
>         Instead, it should be only generating 200 Cancelling for
>         cancel immediately (to stop any CANCEL retransmits) and
>         continue with re-transmitting INVITEs in due course until
>         either transaction timeout occurs in 32 or so seconds or 100
>         Trying finally comes and then outbound CANCEL transaction can
>         be fired immediately and the rest of the logic can proceed as
>         happens now on regular CANCEL.
>
>         I've made a little diagram explaining the current vs. "proper"
>         behavior. You can see it at the link below:
>
>         https://docs.google.com/document/d/1mkNuqvQdw6a6j0iAmjvTssyu-VF-5i4d2Kut4Eg9qLk/pub
>
>         In general this is very non-intuitive, but for INVITE
>         transactions in no circumstances retransmits should be
>         terminated. Once the first INVITE has left the port, there is
>         no way for the  SIP proxy to know if missing provisional
>         response is due to that invite never being received or due to
>         response being lost or some propagation/processing delay in
>         between.
>
>         This issue tracks back to the original SER code and so that
>         all releases are affected.
>
>
>         -Max
>
>
>
>
>
> -- 
> Maksym Sobolyev
> Sippy Software, Inc.
> Internet Telephony (VoIP) Experts
> Tel (Canada): +1-778-783-0474
> Tel (Toll-Free): +1-855-747-7779
> Fax: +1-866-857-6942
> Web: http://www.sippysoft.com
> MSN: sales at sippysoft.com <mailto:sales at sippysoft.com>
> Skype: SippySoft

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opensips.org/pipermail/devel/attachments/20151208/a95a81d7/attachment.htm>


More information about the Devel mailing list